Inspection

CLUTCH PEDAL


Inspection and Adjustment


INSPECTION

The Height of Clutch Pedal
1. Turn the floor carpet.





2. Check that the clutch pedal height "H1" from the dash lower panel (1) is within the reference value.






3. Replace clutch pedal if the height is outside the reference value.

Clutch Pedal Height When Disengaging The Clutch
1. Securely engage the parking brake.
2. Turn the floor carpet.
3. Start the engine and run at idle.
4. Fully depress clutch pedal and shift to the 1st gear.

CAUTION:
Securely depress the brake pedal with shifter lever in 1st gear.





5. Gradually release the clutch pedal and check that the clutch pedal height "H2" from the dash lower panel (1) is within the reference value with a scale immediately before the clutch is engaged.






NOTE:
Although the clutch pedal height differs according to whether the clutch gets disengaged or engaged, clutch-engaged case is regarded as clutch-disengaged case for easier inspection.
6. Replace clutch pedal if the height is outside the reference value.

Clutch Pedal Play





1. Push the pedal pad by hand until a resistance can be felt and check that the play "A" on the upper surface of the pedal pad is within the reference value.






2. Replace clutch pedal if the play is outside the reference value.

Position of Clutch Interlock Switch





Check that the clearance "C" between the thread end of clutch interlock switch (1) and stopper rubber (2) is within the specified value while clutch pedal is fully depressed.






Position of Clutch Pedal Position Switch (With ASCD or With Push-Button Ignition Switch System)





Check that the clearance "A" between the thread end of clutch pedal position switch (1) and clutch pedal (2) is within the specified value while clutch pedal is fully released.






ADJUSTMENT

Position of Clutch Interlock Switch
1. Disconnect the clutch interlock switch connector.
2. Loosen the clutch interlock switch 45 degrees counter clockwise.





3. With the clutch pedal fully depressed, press into the clutch interlock switch (1) until it reaches the stopper rubber (2) and turn the switch clockwise by 45 degrees to secure it.

CAUTION:
The clearance "C" show in the figure must be within the specified value.






NOTE:
Fully depressed clutch pedal means a clutch pedal condition that the clutch pedal lever contacts the pedal stopper rubber.

Position of Clutch Pedal Position Switch (With ASCD or With Push-Button Ignition Switch System)
1. Disconnect the clutch pedal position switch connector.
2. Loosen the clutch pedal position switch 45 degrees counter clockwise.





3. Press-fit the clutch pedal position switch (1) until the clutch pedal position switch hits the clutch pedal (2) 45 degrees clockwise while pulling the pedal pad slightly.

CAUTION:
The clearance "A" show in the figure must be within the specified value.