Install Seal D (Part of Both Kits)

Install Seal D (part of both kits)

^ Seal size (12 mm x 13 mm x 120 mm)





NOTE:
Before beginning, it is recommend that you read all of seal D's installation steps (1a through 1d) and examine Figure 14.

1. Apply EPT seal D as follows:

a. Remove the adhesive backing from seal D.

b. Position the seal as shown in Figure 14.

> Make sure the seal is positioned against the assembly.

> Make sure the seal extends 15 mm below the cable.

c. Wrap the seal around the cables.

d. Press the seal together so it is stuck all the way around each cable and to itself between the cables.