Removal And Installation

REAR DISC BRAKE


BRAKE CALIPER ASSEMBLY : Removal and Installation


REMOVAL

WARNING:
Clean any dust from the brake caliper and brake pads with a vacuum dust collector. Never blow with compressed air.

CAUTION:
- Never spill or splash brake fluid on painted surfaces. Brake fluid may seriously damage paint. Wipe it out immediately and wash with water if it gets on a protect surface. For brake component parts, never wash them with water.
- Never depress the brake pedal while removing the brake hose. If this is not complied with, brake fluid may splash.
- Never drop removed parts.
- If the brake fluid or grease adheres to the disc rotor, quickly wipe it off.
1. Remove tires with power tool.
2. Fix the disc rotor using wheel nuts.
3. Drain brake fluid. Draining.
4. Separate brake hose from caliper assembly. Removal And Installation.





5. Remove torque member mounting bolts, and remove brake caliper assembly.

CAUTION:
Never drop brake pad and caliper assembly.
6. When removing disc rotor.
- 2WD: Removal And Installation.
- AWD: .

INSTALLATION

WARNING:
Clean any dust from the brake caliper and brake pads with a vacuum dust collector. Never blow with compressed air.

CAUTION:
- Never spill or splash brake fluid on painted surfaces. Brake fluid may seriously damage paint. Wipe it out immediately and wash with water if it gets on a protect surface. For brake component parts, never wash them with water.
- Never depress the brake pedal while removing the brake hose. If this is not complied with, brake fluid may splash.
- If the brake fluid or grease adheres to the disc rotor, quickly wipe it off.
1. Install disc rotor.
- 2WD: Removal And Installation.
- AWD: .





2. Install the brake caliper assembly to the axle housing and tighten the torque member mounting bolts to the specified torque.

CAUTION:
Never spill or splash any grease and moisture on the brake caliper assembly mounting face, threads, mounting bolts and washers. Wipe out any grease and moisture.
3. Install brake hose. Removal And Installation.
4. Perform the air bleeding. Service and Repair.
5. Check a drag of rear disc brake. If any drag is found, Inspection.
6. Install tires. Removal And Installation.
7. Perform inspection after installation. Inspection.