Without Intelligent Key System

ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT


ECM : Work Procedure

1.PERFORM ECM RECOMMUNICATING FUNCTION
1. Install ECM.
2. Insert the registered ignition key* into key cylinder, then turn ignition switch ON.
*: To perform this step, use the key that is used before performing ECM replacement.
3. Maintain ignition switch in the ON position for at least 5 seconds.
4. Turn ignition switch OFF.
5. Start the engine.
- GO TO 2.
2.PERFORM ADDITIONAL SERVICE WHEN REPLACING ECM
Perform Work Procedure.
- END