Removal and Installation

PARKING BRAKE CONTROL


Removal and Installation


REMOVAL
1. Remove center console assembly. Removal And Installation.
2. Disconnect parking brake switch connector.
3. Loosen adjusting nut.
4. Remove equalizer from rear cable terminal ends.
5. Remove device assembly nuts, then remove device assembly.
6. Remove rear brake drum or disc rotor. Removal and Installation (drum brake), Removal And Installation Of Caliper Assembly (disc rotor).
7. Remove rear cables from the operating levers. Removal and Installation (drum brake), Removal And Installation Of Caliper Assembly (disc brake).
8. Remove rear cable bolts, and then remove LH and RH rear cables.
9. If replacing LH or RH cable guide, remove carpet and floor insulator. Service and Repair, then perform the following:
- Remove bracket nuts and bracket.
- Remove cable guide bolts and cable guides.
10. Remove adjusting nut, and discard, remove front cable from device assembly (if replacing front cable assembly).

CAUTION:
Do not reuse the adjusting nut.

INSTALLATION
Installation is in the reverse order of the removal.
- Adjust clearance of rear brake shoes. Adjustments.