Mud Flap: Service and Repair

MUDGUARD


Removal and Installation












REMOVAL
1. Remove the screws and mudguard front (if equipped).
2. Remove the screws and mudguard rear (if equipped).
3. Remove the clips and screws, then remove mudguard center from body outer sill reinforcement.
4. Remove the screws and mudguard center bracket rear.
5. Using a trim stick, carefully lift the mudguard center away from the adhesive backed foam tape.
6. Release the adhesive backed foam tape from the body surface

INSTALLATION
Installation is in the reverse order of removal.

NOTE:
- Before installing mudguard center, clean the surface where it will be mounted with isopropyl alcohol or equivalent to degrease the surface.
- Before installing, be sure there are no gaps or waves in the adhesive backed foam tape where the surfaces meet.