Front Wheel Hub and Knuckle

FRONT WHEEL HUB AND KNUCKLE


Inspection


COMPONENT PART
Check that the mounting conditions (looseness, backlash) of each component and component conditions
(wear, damage) are normal.

WHEEL HUB AND BEARING ASSEMBLY
Check the following items, and replace the part if necessary.
- Move wheel hub and bearing assembly in the axial direction by hand. Check there is no looseness of wheel bearing.

Axial end play : Rear Axle

- Rotate wheel hub and bearing assembly and check there is no unusual noise or other irregular conditions. If there is any of irregular conditions, replace wheel hub and bearing assembly.





FRONT WHEEL HUB AND KNUCKLE


Inspection


INSPECTION AFTER REMOVAL
Check the following items, and replace the part it necessary.
- Check components for deformation, cracks, and other damage. Replace if necessary.
- Check boots of transverse link and steering outer socket ball joint for breakage, axial play, and torque. Testing and Inspection and Procedures.

INSPECTION AFTER INSTALLATION
1. Check wheel sensor harness for proper connection. Exploded View.
2. Check the wheel alignment. Front Suspension.
3. Adjust neutral position of steering angle sensor. Special Repair Requirement.