Removal And Installation

WATER OUTLET


Removal and Installation


REMOVAL
1. Drain engine coolant from radiator. Refer to Service and Repair.

CAUTION:
- Perform this step when engine is cold.
- Never spill engine coolant on drive belt.
2. Disconnect radiator hose (upper). Refer to Service and Repair.
3. Disconnect harness connector from engine coolant temperature sensor and block heater, if equipped.
4. Remove electric throttle control actuator water hoses.
5. Remove heater hoses.
6. Remove water outlet.
7. Remove engine coolant temperature sensor from water outlet, if necessary.
8. Remove block heater from water outlet, if necessary (Canada only).

INSTALLATION
Installation is in the reverse order of removal.

NOTE:
Insert the block heater into the water outlet until the clip is fully locked (Canada only).