Front Wiper Does Not Stop

FRONT WIPER AND WASHER SYSTEM


Front Wiper Does Not Stop

1. CHECK CIRCUIT BETWEEN COMBINATION SWITCH AND BCM
With CONSULT-III
1. Select "BCM" on CONSULT-III, and select "WIPER" on "SELECT TEST ITEM" screen.
2. Select "DATA MONITOR". Make sure that "FR WIPER INT", "FR WIPER LOW", "FR WIPER HI", and "FR
WASHER SW" turn ON-OFF according to front wiper switch operation.
Without CONSULT-III
Refer to Component Tests and General Diagnostics.
OK or NG
OK >> Replace IPDM E/R. Refer to Service and Repair.
NG >> Check combination switch (wiper switch). Refer to Component Tests and General Diagnostics.