Parking, License Plate and Tail Lamps Do Not Illuminate

PARKING, LICENSE PLATE AND TAIL LAMPS


Parking, License Plate and Tail Lamps Do Not Illuminate

1. CHECK TAIL LAMP FUSE
Inspect tail lamp 10A fuses (No. 36 and 37, located in IPDM E/R).
OK or NG
OK >> GO TO 2.
NG >> Repair harness.
2. CHECK COMBINATION SWITCH INPUT SIGNAL
With CONSULT-III
1. Select "BCM" on CONSULT-III. Select "HEAD LAMP" on "SELECT TEST ITEM" screen.
2. Select "DATA MONITOR". Make sure "LIGHT SW 1ST" turns ON-OFF linked with operation of lighting switch.

When lighting switch is 1ST position : LIGHT SW 1ST ON

Without CONSULT-III
Refer to Component Tests and General Diagnostics .
OK or NG
OK >> GO TO 3.
NG >> Check combination switch (lighting switch). Refer to Component Tests and General Diagnostics .
3. ACTIVE TEST
With CONSULT-III
1. Select "IPDM E/R" on CONSULT-III, and select "ACTIVE TEST".
2. Select "TAIL LAMP" on "SELECT TEST ITEM" screen.
3. Touch "ON" on "ACTIVE TEST" screen.
4. Make sure parking, license plate and tail lamps operate.

Parking, license plate and tail lamps should operate.

Without CONSULT-III
1. Start auto active test. Refer to Auto Active Test .
2. Make sure parking, license plate and tail lamps operate.

Parking, license plate and tail lamps should operate.

OK or NG
OK >> GO TO 4.
NG >> Replace the IPDM E/R if the parking, license and tail lamps do not start operating after resetting connector. Refer to Service and Repair .
4. CHECK IPDM E/R
1. Select "IPDM E/R" on CONSULT-III, and select "DATA MONITOR".
2. Make sure "TAIL & CLR REQ" turns ON when lighting switch is in 1ST position.

When lighting switch is 1ST position : TAIL&CLR REQ ON

OK or NG
OK >> Replace IPDM E/R. Refer to Service and Repair .
NG >> Replace BCM. Refer to Service and Repair.