Air Breather Hose

Removal and Installation

MT-16 Component:

REMOVAL
1. Disconnect air breather hose clips and disconnect air breather hose from resonator.
2. Remove air breather hose.

CAUTION:
When removing air breather hose, be sure to hold two way connector securely.

INSTALLATION
Installation is in the reverse order of removal.
^ When installing air breather hose on two way connector, aim paint mark face toward the vehicle front.
^ When installing air breather hose on two way connector, push it until it hits transaxle case.
^ When installing air breather hose to resonator, make sure that clips are fully inserted.

CAUTION:
Make sure air breather hose is not collapsed or blocked due to folding or bending when installed.