Removal and Installation

TRANSAXLE ASSEMBLY

MT-67 Component:

Removal and Installation

CAUTION:
If transaxle assembly is removed from the vehicle, always replace CSC (Concentric Slave Cylinder). Inserted CSC returns to the original position when removing transaxle assembly. Dust on clutch disc sliding parts may damage CSC seal, and may cause clutch fluid leakage.

REMOVAL
1. Drain gear oil.
2. Drain clutch fluid and remove clutch tube from CSC.

CAUTION:
Never depress clutch pedal during removal procedure.

3. Remove engine and transaxle assembly.
4. Remove starter motor.
5. Remove transaxle assembly to engine bolts.
6. Separate transaxle assembly from engine.

INSTALLATION
Installation is in the reverse order of removal.
^ If transaxle assembly is removed from the vehicle, always replace CSC.








^ When installing the transaxle assembly to the engine, use the specified tightening torque in the numerical sequence shown:

CAUTION:
When installing transaxle assembly, never allow the transaxle input shaft to make contact with the clutch cover.