Cannot Be Changed to Manual Mode
Cannot Be Changed to Manual ModeSYMPTOM:
Does not change to manual mode when manual shift gate is used.
DIAGNOSTIC PROCEDURE
1.CHECK SELF-DIAGNOSTIC RESULTS
Perform self-diagnosis check. Refer to CVT-46, "CONSULT-III Function (TRANSMISSION)". Consult-III Function (Transmission)
Is any malfunction detected by self-diagnosis?
YES >> Check the malfunctioning system. Refer to CVT-46, "CONSULT-III Function (TRANSMISSION)". Consult-III Function (Transmission)
NO >> GO TO 2.
2.CHECK MANUAL MODE SWITCH
Check the manual mode switch circuit. Refer to CVT-104. P0826
OK or NG
OK >> GO TO 3.
NG >> Repair or replace damaged parts.
3.SYMPTOM CHECK
Check again. Refer to CVT-41, "Cruise Test". Cruise Test
OK or NG
OK >> INSPECTION END
NG >> GO TO 4.
4.CHECK TCM
1. Check TCM input/output signals. Refer to CVT-44, "TCM Input/Output Signal Reference Value". Pinout Values and Diagnostic Parameters
2. If NG, re-check TCM pin terminals for damage or loose connection with harness connector.
OK or NG
OK >> INSPECTION END
NG >> Repair or replace damaged parts.