Diagnostic Procedure 3
DIAGNOSTIC PROCEDURE 3Final Check of SRS Using CONSULT-III-Diagnosis Mode
1. If no DTC is detected on "SELF-DIAG [CURRENT]" repair of SRS is completed. Go to step 2".
If any DTC is detected on SELF-DIAG [CURRENT]", the malfunctioning part has not been repaired completely or another malfunctioning part is being detected. Go to "DIAGNOSTIC PROCEDURE 2"
2. Touch "ERASE".
NOTE: Touch "ERASE" to clear the memory of the malfunction ("SELF-DIAG [PAST]").
If the memory of the malfunction in SELF-DIAG [PAST]" is not erased, the User mode shows the system malfunction by the operation of the warning lamp even if the malfunction is repaired completely.
3. Touch BACK" on CONSULT-III screen. Touch SELF-DIAG [PAST]".
4. Check that no malfunction is detected on SELF-DIAG [PAST]".
5. Touch BACK" on CONSULT-III screen to return to User mode from Diagnosis mode.
6. Turn ignition switch OFF then turn off and disconnect CONSULT-III.
7. Go to SRS-19. SRS Operation Check. [1][2]Component Tests and General Diagnostics