Operation Procedure
OPERATION PROCEDURE1. Turn the ignition switch ON, and switch the odo/trip meter to"trip A"or"trip B" .
NOTE: If the diagnosis function is activated with"trip A "displayed, the mileage on "trip A" will indicate "0000.0" , but the actual trip mileage will be retained. (The same applies for "trip B" .)
2. Turn ignition switch OFF.
3. While pushing the odo/trip meter switch (1), turn the ignition switch ON.
4. Confirm that the trip meter displays "0000.0" .
5. Push the odo/trip meter switch at least 3 times. (Within 7 seconds after the ignition switch is turned ON.)
6. All segments on the odo/trip meter illuminate. At this time, the unified meter control unit is turned to self-diagnosis mode.
NOTE:
- Check combination meter power supply and ground circuit when self-diagnosis mode of combination meter does not start. Replace combination meter if normal.
- If any of the segments is not displayed, replace combination meter.
7. Each meter activates while pressing odo/trip meter switch.
NOTE: If the speedometer or tachometer are not activated, replace combination meter.