Shift Cable: Service and Repair

SHIFT CONTROL SYSTEM

Removal and Installation

Exploded View CVT-187:

REMOVAL

CAUTION: Make sure that parking brake is applied before removal and installation.

1. Place the selector lever in the P position.
2. Remove the IP center assembly.
3. Disconnect the CVT device harness connector.
4. Remove the key interlock cable from the control device assembly.
5. Remove the control cable from the control device assembly.
6. Remove the nuts and the control device assembly.

INSTALLATION
Installation is in the reverse order of removal.





^ When installing the control cable (3) to the control device assembly (2), make sure that the control cable socket is fully pressed into the control device assembly (2), and the control cable end (1) is fully pressed in with the ribbed surface (A) facing towards the front of the vehicle.
<-: Vehicle front
^ After installation is completed, adjust and check the CVT position.