Steering Wheel: Service and Repair

Exploded View PS-9:

STEERING WHEEL

Removal and Installation
REMOVAL

NOTE: When reconnecting spiral cable, fix cable with a tape so that fixing case and rotating part keep aligned. This will omit neutral position alignment procedure during spiral cable installation.

1. Set vehicle to the straight-ahead position.
2. Remove driver air bag module.
3. Remove steering wheel lock nut after steering is locked.





4. Remove steering wheel using Tool.
Tool number A: ST27180001 (J-25726-A)

INSTALLATION
Installation is the reverse order of removal. For tightening torque, refer to Exploded View PS-9.

NOTE: Check the spiral cable neutral position after replacing or rotating spiral cable.

CAUTION: Do not twist spiral cable freely on excessively after it becomes tight (doing so may cause the cable to be turn off).