Air Bag(s) Arming and Disarming: Service and Repair

CAUTION:
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables, then wait at least 3 minutes.
- Do not attempt to repair or replace damaged direct-connect SRS component connectors. If a driver air bag direct-connect harness connector is damaged, the spiral cable must be replaced.
- Do not insert any foreign objects (screwdriver, etc.) into air bag module or harness connectors.
- After the work is completed, perform self-diagnosis to check that no malfunction is detected. Refer to SRS-20, "SRS Operation Check". [1][2]Component Tests and General Diagnostics