Front

REMOVAL OF SEAT BELT RETRACTOR
1. Disconnect both the negative and positive battery cables, then wait at least 3 minutes.
2. Remove the seat belt adjuster cover and shoulder anchor bolt.
3. Remove the outer anchor cover, then the outer anchor bolt.
4. Remove the center pillar lower garnish. Refer to "BODY SIDE TRIM".
5. Position the floor trim away from center pillar.




6. Disconnect seat belt pre-tensioner connector. Refer to "Direct-connect SRS Component Connectors".
7. Remove the retractor anchor bolt, then remove the seat belt retractor.

INSTALLATION OF SEAT BELT RETRACTOR
Installation is in the reverse order of removal.