Parking Brake Control: Service and Repair

PARKING BRAKE CONTROL

Exploded View PB-5:

Removal and Installation
REMOVAL
1. Remove center console assembly.
2. Disconnect parking brake switch connector.
3. Loosen adjusting nut.
4. Remove equalizer from rear cable terminal ends.
5. Remove device assembly mounting nuts, then remove device assembly.
6. Remove rear brake drum or disc rotor.
7. Remove rear cables from the operating levers.
8. Remove rear cable bolts, and then remove rear cables.
9. Remove bracket nuts and bracket.
10. Remove cable guide bolts and cable guides.
11. Remove adjusting nut and front cable from device assembly (if replacing front cable assembly).

INSTALLATION
1. Installation is in the reverse order of the removal. Tighten mounting bolts and nuts to the specified torque.
2. Adjust clearance of rear brake shoes.