Brake Pedal Assy: Adjustments
Inspection and AdjustmentPLAY AND CLEARANCE BETWEEN BRAKE PEDAL AND FLOOR PANEL WITH PEDAL DEPRESSED
^ Check brake pedal play.
^ Check brake pedal initial height "H1" from dash lower panel (1) using Tool.
Tool: - (J-46532)
^ Make an adjustment to the following dimension if value is outside the standard.
ADJUSTMENT
1. Loosen stop lamp switch and ASCD switch (if equipped) by rotating it counterclockwise by 45°.
2. Loosen lock nut on input rod, then rotate input rod to set pedal to the specified height, and tighten lock nut.
CAUTION: Make sure that the threaded end of input rod stays inside clevis.
3. With the pedal pulled and held by hand, press stop lamp switch or ASCD switch (if equipped) until its threaded end contacts brake pedal lever.
4. With the threaded end of stop lamp switch or ASCD switch (if equipped) contacting brake pedal lever, rotate the switch clockwise by 45° to secure.
CAUTION: Make sure that the clearance (C) is within the standard.
5. Check the pedal play.
CAUTION: Make sure that stop lamps go off when brake pedal is released.
6. Start engine to check brake pedal depressed height.