Removal and Installation

Removal
1. Drain brake fluid.

CAUTION: Be careful not to splash brake fluid on painted areas; it may cause paint damage. If brake fluid is splashed on painted areas, wash it away with water immediately.

2. Remove union bolt and clutch hose from operating cylinder.
3. Remove operating cylinder mounting bolts, and remove cylinder from vehicle.

Installation
Install the components in the reverse order of removal. Adhere to the operations described below.

CAUTION: Install the hose without twisting it.
^ The copper washer of the union bolt should not be reused. Always use a now copper washer for installation.
^ After finishing the operation, bleed air from the clutch piping connector and operating cylinder.