Removal and Installation

Removal
1. Drain brake fluid.

CAUTION: Be careful not to splash brake fluid on painted areas; it may cause paint damage. If brake fluid is splashed on painted areas, wash it away with water immediately.

2. Remove clutch tube using a flare nut wrench.
3. Remove snap pin between clutch pedal and push rod, and remove clevis pin.
4. Unscrew master cylinder assembly mounting nuts and remove master cylinder assembly from vehicle.

Installation
1. Connect clutch tube to master cylinder assembly, and hand-tighten flare nut.
2. Install master cylinder assembly to vehicle, and tighten mounting nuts to the specified torque.
8 - 11 Nm (0.8 - 1.1 kg-m, 69 - 96 inch lbs.)
3. Tighten clutch tube flare nut using a flare nut torque wrench.
15 - 18 Nm (1.5 - 1.8 kg-m, 11 - 13 ft. lbs.)
4. After installing clevis pin, install snap pin to connect clutch pedal to push rod.
5. After finishing the operation, bleed air from clutch piping connector and operating cylinder.