Removal and Installation

CAUTION:
- Before servicing SRS, turn the ignition switch OFF, disconnect both battery cables and wait at least 3 minutes.
- Check front seat belt pre-tensioner with load limiter for proper installation.
- After replacement of front seat belt pre-tensioner, check SRS function and perform self-diagnosis for SRS. Refer to "Self-diagnosis" for details.
- Do not attempt to disassemble front seat belt pre-tensioner with load limiter.
- Replace front seat belt pre-tensioner if it has been dropped or sustained an impact.
- Do not expose front seat belt pre-tensioner to temperatures exceeding 80 °C (176 °F).

Front Seat Belt:

REMOVAL AND INSTALLATION

1. Slide the seat all the way forward and tilt the seat back toward the front.
2. Remove adjuster cover.A
3. Remove floor anchor bolt.B
4. Remove shoulder anchor bolt.C
5. Remove center pillar upper and lower garnish.
6. Disconnect front seat belt pre-tensioner connector.
7. Remove the screw securing front seat belt pre-tensioner retractor, then remove seat belt and seat belt pre-tensioner retractor.
8. Remove bolts securing seat belt adjuster, then remove seat belt adjuster.

NOTE: To install, reverse the removal procedure sequence.