Without Scan Tool

Without CONSULT-II

After a malfunction is repaired, switch the ignition "OFF" for at least one second, then back "ON". Diagnosis mode returns to the User mode. At that time, the self-diagnostic result is cleared.

HOW TO CHANGE SELF-DIAGNOSIS MODE WITHOUT CONSULT-II




From User Mode to Diagnosis Mode
Diagnosis mode is activated by pressing the front door switch LH at least 5 times within 7 seconds after turning the ignition switch ON. If no malfunction is detected, SRS will not enter Diagnosis mode.

From Diagnosis Mode to User Mode
To return to User mode while a malfunction is being detected, turn ignition switch OFF, then back ON and press the front door switch LH at least 5 times within 7 seconds.

After a malfunction is repaired, turn ignition switch OFF for at least one second, then back ON. Diagnosis mode returns to User mode.