Hydraulic Control Assembly - Antilock Brakes: Service and Repair

REMOVAL
1. Disconnect negative battery cable.
2. Drain brake fluid.
3. Remove the A/C high pressure and A/C low pressure lines.
4. Remove mounting bracket bolts and nuts.
5. Disconnect harness connector and brake lines.

INSTALLATION
1. Connect brake lines temporarily.
2. Tighten bolts.
3. Tighten brake lines.
4. Connect harness connector and negative battery cable.
5. Refill and bleed the brake fluid. Then bleed air.
6. Install the A/C high pressure and AIC low pressure lines. Evacuate and recharge the A/C system.