Air Flow Meter/Sensor: Service and Repair

AIR CLEANER AND AIR DUCT

Removal and Installation

REMOVAL
1. Disconnect the harness connector from the mass air flow sensor.
2. Disconnect the tube clamp at the electric throttle control actuator and at the fresh air intake tube.
3. Remove air cleaner to electric throttle control actuator tube, air cleaner case (upper) with the mass air flow sensor attached.
4. Remove mass air flow sensor from air cleaner case (upper), as necessary.

CAUTION: Handle mass air flow sensor with care.
- Do not shock it.
- Do not disassemble it.
- Do not touch its sensor.
5. Remove resonator in the fender, lifting left fender protector, as necessary.

INSTALLATION
Installation is in the reverse order of removal.