System Description For Meters and Gauges

UNIFIED CONTROL METER
- Speedometer, odo/trip meter, tachometer, fuel gauge and water temperature gauge are controlled totally by control unit built-in combination meter.
- Digital meter is adopted for odo/trip meter.*
*The record of the odo meter is kept even if the battery cable is disconnected. The record of the trip meter is erased when the battery cable is disconnected.
- Odo/trip meter is indicated for about 30 seconds after ignition switch has been turned OFF.
- Odo/trip meter segment can be checked in diagnosis mode.
- Meter/gauge can be checked in diagnosis mode.





HOW TO CHANGE THE DISPLAY FOR ODO/TRIP METER

NOTE: Turn ignition switch to the "ON" position to operate odo/trip meter.

POWER SUPPLY AND GROUND CIRCUIT
Power is supplied at all times
- through 10 A fuse [No.24, located in the fuse block (J/B)]
- to combination meter terminal (18)
With the ignition switch in the ON or START position, power is supplied
- through 10 A fuse [No.12, located in the fuse block (J/B)]
- to combination meter terminal (17)
Ground is supplied
- to combination meter terminals (17)
- through body grounds (M2) and (M61).