Driver Air Bag Module

Unless the vehicle is being scrapped, deploying the air bag module in the vehicle is not recommended. This may cause damage to the vehicle interior.
Anchor air bag module bracket [kV991 05300 (J41246)] in a vise secured to a firm foundation during deployment.






Deployment of driver air bag module (outside of vehicle)
1. Prepare two sets of nuts and bolts (see figure at left). These bolts are required to secure driver air bag module to the vise.
2. Install one set of nuts and bolts to each side of driver air bag module.

CAUTION: Make sure to install a bolt and nut on each side.






3. Firmly place two nuts (secured to driver air bag module) in the vise.

CAUTION: Ensure that these two nuts are equally placed in the vise. Never finish the installation with just one nut.

4. Connect deployment tool [SST: kV99106400 (J38381)] to driver air bag module connector.






5. Connect red dip of deployment tool to battery positive terminal and black clip to negative terminal.
6. The lamp on the right side of the tool, marked "deployment tool power", should glow green, not red.
7. Press the button on the deployment tool. The left side lamp on the tool, marked "air bag connector voltage", will illuminate and the air bag module will deploy.

CAUTION: When deploying the air bag module. stand at least 5 m (16 ft) away from the air bag module.