Electronic Brake Control Module: Description and Operation

ABS Function





The control unit computes the wheel rotating speed by the signal current sent from the sensor. Then it supplies a DC current to the actuator solenoid valve. It also controls ON-OFF operation of the valve relay and motor relay. If any electrical malfunction should be detected in the system, the Anti-lock Brake System (ABS) warning lamp is turned on. In this condition, the ABS will be deactivated, and the vehicle's brake system reverts to normal operation.

TCS function





Drive wheel slippage is detected by the 4-wheel rotating speed signal. When the wheel slip becomes excessive, the Traction Control System (TCS) operates, causing the SLIP indicator lamp to flash. And, at the same time, a fuel-cut signal to be sent to the Engine Control Module (ECM) and a signal requiring a change in the shift schedule is sent to the Transmission Control Module (TCM). When the TCS OFF switch is used to cancel TCS function, the TCS OFF indicator lamp will light. (TCS does not activate.) In case of a malfunction in the TCS, both the SLIP indicator lamp and the TCS OFF indicator lamp will light, while shutting down the TCS system operation. The vehicle will operate in the same way as a vehicle not equipped with the TCS.