Vehicle Speed Sensor - MTR

DESCRIPTION
The vehicle speed sensor-MTR is built into the speedometer assembly. The sensor functions as an auxiliary device to the revolution sensor when it is malfunctioning. The TCM will then use a signal sent from the vehicle speed sensor-MTR.




TCM TERMINALS AND REFERENCE VALUE
Remarks Specification data are reference values.




ON BOARD DIAGNOSIS LOGIC

DIAGNOSTIC TROUBLE CODE (DTC) CONFIRMATION PROCEDURE

CAUTION:
- Always drive vehicle at a safe speed.
- If conducting this "DTC CONFIRMATION PROCEDURE" again, always turn ignition switch "OFF" and wait at least 5 seconds before continuing.
After the repair, perform the following procedure to confirm the malfunction is eliminated.







With Consult
1. Turn ignition switch "ON" and select "DATA MONITOR" mode for "A/T" .
2. Start engine and accelerate vehicle from 0 to 25 KPH (0 to 16 MPH).

OR




Without Consult
1. Start engine.
2. Drive vehicle under the following conditions:
Selector lever in "D" and vehicle speed higher than 25 KPH (16 MPH).
3. Perform self-diagnosis.
Refer to TCM SELF-DIAGNOSTIC PROCEDURE (No Tools).




DIAGNOSTIC PROCEDURE