With Manufacturer's Scan Tool (CONSULT)

How to erase DTC (With CONSULT)

NOTE: If the diagnostic trouble code is not for A/T related items, skip steps 2 through 4.

1. If the ignition switch stays "ON" after repair work, be sure to turn ignition switch "OFF" once. Wait at least 5 seconds and then turn it "ON" (engine stopped) again.
2. Turn CONSULT "ON" and touch "A/T".
3. Touch "SELF-DIAG RESULTS".
4. Touch "ERASE". [The DTC in the TCM (Transmission Control Module) will be erased.] And touch "BACK" twice.
5. Touch "ENGINE".
6. Touch "SELF-DIAG RESULTS".
7. Touch "ERASE". (The DTC in the ECM will be erased.)
If DTCs are displayed for both ECM and TCM (Transmission Control Module), they need to be erased individually for both ECM and TCM (Transmission Control Module).