Entering Diagnostic Mode (Self Diagnosis)
ON BOARD DIAGNOSTIC SYSTEM FUNCTION
The on board diagnostic system has the following four functions.
1. BULB CHECK : This function checks the MIL bulb for damage (blown, open circuit, etc.).
2. MALFUNCTION WARNING : This is a usual driving condition. When a malfunction is detected twice in two consecutive driving cycles (two trip detection logic), the MIL will light up to inform the driver that a malfunction has been detected. Only the following malfunctions with light up or blink the MIL even in the 1st trip.
- "Misfire (Possible three way catalyst damage)"
- "Closed loop control"
- Fail-Safe item (EXCEPT "START SIGNAL CIRCUIT")
3. SELF-DIAGNOSTIC RESULTS: This function allows DTC and 1st trip DTC to be read.
4. FRONT HEATED OXYGEN SENSOR MONITOR: This function allows the fuel mixture condition (lean or rich), monitored by front heated oxygen sensor, to be read.
DIAGNOSTIC TEST MODE I-BULB CHECK
In this mode, the MALFUNCTION INDICATOR LAMP on the instrument panel should stay ON. It it remains OFF, check the bulb.
DIAGNOSTIC TEST MODE II-SELF-DIAGNOSTIC RESULTS
In this mode, the DTC and 1st trip DTC are indicated by the number of blinks of the MALFUNCTION INDICATOR LAMP
The DTC and 1st trip DTC are displayed at the same time. If the MIL does not illuminate in diagnostic test mode 1 (Malfunction warning), all displayed items are 1st trip DTC's. If only one code is displayed when the MIL illuminates in diagnostic test mode II (SELF-DIAGNOSTIC RESULTS), it is a DTC; if two or more codes are displayed, they may be either DTC's or 1st trip DTC's. DTC No. is same as that of 1st trip DTC. These unidentified codes can be identified by using the consult or GST A DTC will be used as an example for how to read a code.
Long (0.6 second) blinking indicates the two LH digits of number and short (0.3 second) blinking indicates the two RH digits of number. For example, the malfunction indicator lamp blinks 10 times for 6 seconds (0.6 sec x 10 times) and then it blinks three times for about 1 second (0.3 sec x 3 times). This indicates the DTC "1003" and refers to the malfunction of the park/neutral position switch.
In this way, all the detected malfunctions are classified by their diagnostic trouble code numbers. The DTC "0505" refers to no malfunction. (See DIAGNOSTIC TROUBLE CODE CHART.)
DIAGNOSTIC TEST MODE II-FRONT HEATED OXYGEN SENSOR MONITOR
In this mode, the MALFUNCTION INDICATOR LAMP displays the condition of the fuel mixture (lean or rich) which is monitored by the front heated oxygen sensor.
To check the front heated oxygen sensor function, start engine in the Diagnostic Test Mode II and warm it up until engine coolant temperature indicator points to the middle of the gauge.
Next run engine at about 2,000 rpm for about 2 minutes under no-load conditions. Then make sure that the MALFUNCTION INDICATOR LAMP comes ON more than 5 times within 10 seconds with engine running at 2,000 rpm under no-load.