Removal

CAUTION: When removing the transmission assembly from engine, first remove the crankshaft position sensor (OBD) from the assembly. Be careful not to damage sensor edge and ring gear teeth.


- Remove exhaust tube.
- Remove support bracket from M/T assembly.
- Remove control rod from shift lever.





- Remove crankshaft position sensor (OBD) from transmission.


- Remove propeller shaft.
- Insert plug into rear oil seal after removing propeller shaft.
- Be careful not to damage spline, sleeve yoke and rear oil seal when removing propeller shaft.
- Disconnect reverse lamp switch, neutral position switch and vehicle speed sensor harness connectors.
- Support manual transmission with a jack.
- Remove rear mounting.




- Lower manual transmission.
- Lower manual transmission as much as possible.
- Remove transmission fixing bolts.
- Remove transmission from engine.
- Support manual transmission while removing it.