Removal And Installation

Removal





1. Remove battery and bracket.
2. Remove air cleaner box with mass air flow sensor.
3. Remove air duct.





4. Remove clutch operating cylinder from transaxle.
5. Disconnect back-up lamp switch harness connectors.




6. Remove starter motor from transaxle.





7. Remove shift control rod from transaxle.
8. Drain gear oil from transaxle.




9. Draw out drive shafts from transaxle.

10. Support engine by placing a jack under oil pan.

CAUTION: Do not place jack under oil pan drain plug.






11. Remove rear and LH mounts.





12. Raise jack for access to lower housing bolts. Remove bolts. Lower jack.
13. Remove bolts securing transaxle.





14. Lower transaxle while supporting it with a jack.


Installation


1. Reverse procedure to install.




Note: Tighten bolts securing transaxle.