Band: Testing and Inspection

Low & Reverse Brake

INSPECTION
Low and reverse brake snap ring and spring retainer
^ Check for deformation, or damage.

Low and reverse brake return springs

Inspection Standard:

^ Check for deformation or damage. Also measure free length and outside diameter.

Low and reverse brake drive plates




^ Check facing for burns, cracks or damage.
^ Measure thickness of facing.
- Thickness of drive plate:
Standard value: 2.0 mm (0.079 in)
Wear limit: 1.8 mm (0.071 in)
^ If not within wear limit, replace.

Low one-way clutch inner race




^ Check frictional surface of inner race for wear or damage.




^ Install a new seal rings onto low one-way clutch inner race.
^ Be careful not to expand seal ring gap excessively.
^ Measure seal ring-to-groove clearance.
- Inspection standard:
Standard value: 0.10-0.25 mm (0.0039-0.0098 in)
Allowable limit: 0.25 mm (0.0098 in)
^ If not within allowable limit, replace low one-way clutch inner race.