Removal

When removing center bolt, hold clutch disc with clutch disc wrench.





^ Remove the clutch disc using the clutch disc puller. Insert the holder's three pins into the holes in the clutch disc. Rotate the holder clockwise to hook it onto the plate. Then, tighten the center bolt to remove the clutch disc. After removing the clutch disc, remove the shims from either the drive side or the clutch disc.





^ Remove the snap ring using external snap ring pliers.





^ Pulley removal

Use any commercially available pulley puller. Position the center of the puller on the end of the drive shaft, and remove the pulley assembly.
To prevent the pulley grove from being deformed, the puller claws should be positioned onto the edges of the pulley assembly.





^ Remove the field coil harness clip using a screwdriver.





^ Remove the snap ring using external snap ring pliers.