Sentra Wagon

1. Remove rear seat.


2. Remove rear shock absorber caps and wheelhouse finishers. It is recommended that the shock absorber caps are replaced with retro-fit caps listed in the parts information section.


3. Remove rear pillar finishers.


4. Locate the drilling point which is factory pre-scribed in the rear pillar finishers.
5. Using a 1" hole saw, drill the finisher at the marked location.
6. Remove original lap belts (female buckle side).


7. Install female buckle lap belts from retro-fit kit. Torque mounting bolts to 26-32 ft.lbs. (3.65-4.65 kg/m).


8. Remove the retracting side of the original lap belts.


9. The retracting side of the retro-fit lap belt is installed in two steps. First, install the retractor unit end of the shoulder harness. Then place the wheelhouse finisher and retro-fit shock absorber cap into position. Bolt the shoulder anchor into the rear side panel where the 1" hole was drilled.

NOTE: Anchor/mounting bolt torque is 26-32 ft.lbs. (3.65-4.65 kg/m).


10. Fully tighten the wheelhouse panel finishers.


11. Check the retro-fit lap belts for smooth operation.


12. Reinstall rear seat.