Precautions For "Air Bag" / "Seat Belt Pre-Tensioner" Service

Precautions for SRS "Air Bag" and "Seat Belt Pre-tensioner" Service
- Do not use a circuit tester to check SRS circuits unless instructed.
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes.

For approximately 3 minutes after the cables are removed, it is still possible for the air bags and seat belt pre-tensioners to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.

- Air bag diagnosis sensor unit must always be installed with forward mark "<-" pointing toward the front of the vehicle for proper operation. Also check air bag diagnosis sensor unit for deformities, dents, cracks and rust before installation and replace as required.
- The spiral cable must be aligned in the neutral position since its rotations are limited. Do not rotate steering column while steering gear is removed to avoid damaging spiral cable.
- Handle air bag module carefully. Always place it with air bag lid surface facing upward.
- Conduct self-diagnosis to check entire SRS for proper function after replacing any components. Refer to "SRS Operation Check".
- After air bag inflates, the instrument panel assembly should be replaced if damaged.