ABS Actuator and Electric Unit
ABS Actuator and Electric UnitREMOVAL
ABS/VDC/TCS ACTUATOR AND ELECTRIC UNIT:
1. Disconnect battery cable.
2. Disconnect connector and brake pipes.
3. Remove fixing bolts.
INSTALLATION
CAUTION: After installation, refill brake fluid. Then bleed air.
1. Connect brake pipes temporarily.
2. Tighten fixing bolts.
3. Tighten brake pipes.
Tightening torque:......................16.7 - 21.6 Nm (1.7 - 2.2 kgf-m, 13 - 15 ft. lbs.)
4. Connect connector and battery cable.
5. Adjust steering angle sensor neutral position. Refer to "Adjustment of Steering angle Sensor Neutral Position".
Steering Angle Sensor