13. Engine System
Inspection 13 - Engine Signal 1 - Engine SystemDTC C1130
1. CHECKING SELF-DIAGNOSIS RESULTS (1)
Check self-diagnosis results.
Self-diagnosis results
CONSULT-II display items
ENGINE SIGNAL 1
Do self-diagnosis results indicate anything other than the above?
YES >> Perform repair or replacement for the item indicated.
NO >> GO TO 2.
2. HECK ENGINE SYSTEM
1. Perform self-diagnostic procedures for ECM.
Self-diagnosis results
CONSULT-II display items
P0101, P0102 MAF SENSOR*1
P0117, P0118 ECT SENSOR*1
P0121, P0122, P0123 TP SENSOR*1
P0125 ECT SENSOR*1
P0605 ECM*1
P1336 CKP SENSOR (COG)-1
IGNITION SIGNAL*1
* 1 Out of ECM diagnostic items, the 7 items listed above cause VDC to be suspended (VDC OFF and SLIP indicators ON) and allow ABS actuator and electric unit (control unit) to indicate "ENGINE SIGNAL 1".
Do any of the above self-diagnostic items appear on the display?
YES >> Refer to Powertrain Management.
NO >> GO TO 3.
3. CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) TO ECM CIRCUIT
Do "ECM-ABSTCS COMM NG" and/or "ABS-TCS C/U SIGNAL" (ECM self-diagnostic items) * 2 appear on display?
* 2 Items which cause VDC to be suspended (VDC OFF and SLIP indicators ON) and allow ABS actuator and electric unit (control unit) to indicate "ENGINE CHECK SIG".
YES >> Refer to "Inspection 15 ENG CHECK SIG - LAN Monitoring", "Inspection 16 LAN SIGNAL 2 - LAN Communication Start Procedure Incomplete" and "Inspection 17 LAN COMM 1 - LAN Communication System Failure".
16. LAN Signal 2 - LAN Communication Start Incomplete
17. LAN Comm 1 - LAN Communication System Failure
NO >> GO TO 4.
4. CHECK SELF-DIAGNOSTIC ITEMS
Check self-diagnostic items.
Do any other ECM self-diagnostic items appear?
YES >> Refer to Powertrain Management.
NO >> Inspection end.