Seat Belt Reminder Buzzer: Description and Operation

WARNING CHIME

System Description

Seat Belt Warning Chime
The warning chime will sound for approximately 6 seconds when the ignition switch is turned from OFF to ON with the driver's seat belt unfastened (seat belt buckle switch ON).
Ground is supplied
- to warning chime unit terminal 2
- through seat belt buckle switch terminal 1.

Seat belt buckle switch terminal 2 is grounded through body grounds M14 and M68.

MODELS WITH POWER DOOR LOCKS
The warning chime is controlled by the smart entrance control unit.
Power is supplied at all times
- through 7.5 A fuse [No. 28, located in the fuse block (J/B)]
- to key switch terminal 1, and
- to smart entrance control unit terminal 49.

Power is supplied at all times
- through 15 A fuse (No. 39, located in the fuse and fusible link box)
- to lighting switch terminal 11.

With the ignition switch in the ON or START position, power is supplied
- through 10 A fuse [No. 5, located in the fuse block (J/B)]
- to smart entrance control unit terminal 27.

Ground is supplied to smart entrance control unit terminals 43 and 64 through body grounds M14 and M68.
When a signal, or combination of signals, is received by the smart entrance control unit, the warning chime will sound.

Seat Belt Warning Chime
The warning chime will sound for approximately 6 seconds when the ignition switch is turned from OFF to ON with the driver's seat belt unfastened (seat belt buckle switch ON).
Ground is supplied
- to smart entrance control unit terminal 28
- through seat belt buckle switch terminal 1.

Seat belt buckle switch terminal 2 is grounded through body grounds M14 and M68.