Oil Filter: Service and Repair

OIL FILTER BRACKET
1. Remove oil filter.
2. Disconnect oil pressure switch and connector.
3. Remove oil filter bracket.








Changing Oil Filter
The oil filter is a small, full-flow cartridge type and is provided with a relief valve.
Use Tool KV10115801 (J38956) for removing oil filter.






1. Remove oil filter with Tool.

WARNING: Be careful not to burn yourself, as the engine and engine oil are hot.

The filter is a full-flow cartridge type and is provided with a relief valve.






2. Clean oil filter mounting surface on cylinder block. Coat rubber seal of new oil filter with engine oil.






3. Screw in the oil filter until a slight resistance is felt, then tighten an additional 2/3 turn.

4. Add engine oil.
Clean excess oil from engine.