Removal

R200A - Front Final Drive:

R200A - Front Final Drive / REMOVAL
1. Remove front propeller shaft.
2. Separate drive shaft from front final drive.
3. Remove engine mounting bolts and raise up engine.
4. Remove front final drive together with differential mounting member.

CAUTION: Be careful not to damage spline, sleeve yoke and front oil seal when removing propeller shaft.
Before removing the final drive assembly or rear axle assembly, disconnect the ABS sensor harness connector from the assembly and move it away from the final drive/rear axle assembly area. Failure to do so may result in the sensor wires being damaged and the sensor becoming inoperative.