Hazard Warning Lamps: Description and Operation

HAZARD LAMP OPERATION
Power is supplied at all times to hazard switch terminal 3 through:
- 10 A fuse [No.17 located in the fuse block (J/B)].

With the hazard switch in the ON position power is supplied
- through hazard switch terminal 1
- to combination flasher unit terminal B
- through combination flasher unit terminal L
- to hazard switch terminal 4.

Ground is supplied to combination flasher unit terminal E through body grounds M14 and M68.

Power is supplied through hazard switch terminal 5 to
- front combination lamp LH terminal 1
- combination meter terminal 12 and
- rear turn signal lamp LH terminal +.

Power is supplied through hazard switch terminal 6 to
- front combination lamp RH terminal 1
- combination meter terminal 14 and
- rear turn signal lamp RH terminal +.

Ground is supplied to front combination lamp LH/RH terminal 2 through body grounds E12 and E54. Ground is supplied to combination meter terminal 13 and rear turn signal lamp LH/RH terminal - through body grounds M14 and M68.

With power and ground supplied the combination flasher unit controls the flashing of the hazard warning lamps.