Case Components

ASSEMBLY





1. Install front cover oil seal.
- Apply multi-purpose grease to seal lip.
2. Install selected counter gear front bearing shim onto transmission case.
- Apply multi-purpose grease.
3. Apply sealant to mating surface of transmission case.





4. Install gear assembly onto transmission case.
5. Install check spring and check ball into interlock stopper.
- Apply multi-purpose grease to check ball.





6. Install interlock stopper assembly and then tighten check ball plug.
- Apply sealant to thread of check ball plug. Refer to "Shift Control Components", under Manual Transmission/Transaxle; Service and Repair; Transmission Overhaul; Major Overhaul.





7. Install stopper ring and main drive bearing snap ring.





8. Install front cover and gasket.
- Apply sealant to thread of 3 bolts shown. Refer to "Case Components", under Manual Transmission/Transaxle; Service and Repair; Transmission Overhaul; Major Overhaul.
9. Apply sealant to mating surface of adapter plate.





10. Install OD gear case together with striking arm.





11. Install retaining pin into striking arm.





12. Install return spring and check ball and then install control housing.
- Apply sealant to mating surface of OD gear case. Refer to "Case Components", under Manual Transmission/Transaxle; Service and Repair; Transmission Overhaul; Major Overhaul.





13. Tighten control housing bolts.
Bolt head size:
A bolts 12 mm (0.47 inch)
B bolts 13 mm (0.51 inch)