With Consult-II
DESCRIPTION^ The purpose of this test is to determine overall performance of the A/T and analyze causes of problems.
^ The road test consists of the following three parts:
a) Check before engine is started
b) Check at idle
c) Cruise test
^ Before road test, familiarize yourself with all test procedures and items to check.
^ Conduct tests on all items until specified symptom is founded. Troubleshoot items which check out No Good after road test.
1.CHECK BEFORE ENGINE IS STARTED
Check 1
Checks 2 and 3
2.CHECK AT IDLE
Checks 1 - 4
Checks 5 - 7
3.CRUISE TEST
^ Check all items listed in Parts 1 through 3.
^ Using CONSULT-II, conduct a cruise test and record the result.
^ Print the result and ensure that shifts and lock-ups take place as per "Shift Schedule".
CONSULT-II Setting Procedure
1. Turn ignition switch OFF.
2. Connect "CONSULT-II" to Data Link Connector. Data link connector is located in the lower instrument panel on driver side.
3. Turn ignition switch ON.
4. Touch "START".
5. Touch "A/T".
6. Touch "DATA MONITOR".
7. Touch "MAIN SIGNALS" or "TCM INPUT SIGNALS".
8. See "Numerical Display", "Barchart Display" or "Line Graph Display".
9. Touch "SETTING" to set recording condition ("AUTO TRIG" or "MANU TRIG") and touch "BACK".
10. Touch "START".
11. When performing cruise test, touch "RECORD".
12. After finishing cruise test part 1, touch "STOP".
1 of 2
2 of 2
13. Touch "STORE" and touch "BACK".
14. Touch "DISPLAY".
15. Touch "PRINT".
16. Check the monitor data printed out.
17. Continue cruise test part 2 and 3.
CRUISE TEST - PART 1
Check 1
Checks 2 and 3
Checks 4 - 6
Checks 7 and 8
CRUISE TEST - PART 2
Checks 1 and 2
Checks 3 and 4
CRUISE TEST - PART 3
Checks 1 and 2
Checks 3 and 4
Checks 5 and 6
Check 7