Fuel Tank: Service and Repair

1. Release fuel pressure from fuel line.
Refer to "Fuel Pressure Release".




2. Disconnect battery ground cable.
3. Remove back seat bottom. Refer to "Removal and Installation".
4. Remove inspection hole cover located under rear seat.
5. Drain fuel from fuel tank.
6. Disconnect electrical connectors.
7. Remove filler protector.
8. Remove the quick connectors as follows.
- Put mating marks on the connectors for correct installation.




- Hold the sides of the connector, push in tabs, and pull out the tube inserted in the retainer.

CAUTION: The tube can be removed when the push in tabs are completely depressed. Do not use any tools to remove the quick connector.




9. Disconnect filler hose, vent and evaporation hose at fuel tank side.




10. Remove fuel tank protector.




11. Remove fuel tank mounting bolts while supporting fuel tank.
12. Remove fuel tank.




To install, reverse the removal procedure. Connect the quick connectors as follows.
- Align push in tabs with retainer openings.
- Insert tube into the center of the connector until you hear a click.




After connecting quick connectors, make sure the connection is firmly made using the following method.
- Pull on the fuel tube and connector to make sure they are firmly connected.
- Start the engine, increase engine speed and verify that there are no leaks.