Front Axle

PRECAUTIONS
- When installing rubber parts, final tightening must be carried out under unladen condition* with tires on ground.
* Fuel, radiator coolant and engine oil full. Spare tire, jack, hand tools and mats in designated positions.





- Use flare nut wrench when removing and installing brake tubes.
- After installing removed suspension parts, check wheel alignment and adjust if necessary.
- Always torque brake lines when installing.

CAUTION:
- The ZF100 (wheel side) type joint assembly has two types of boot material; one is made of rubber and the other is made of resin.
- Do not disassemble the joint assembly with the resin boot. If the boot or joint is damaged, replace the drive shaft assembly.