General Specifications
| Surface Flatness | Standard | Less Than 0.03 Millimeter (mm) | |
| Cylinder Bore Inner Diameter | Standard (for No.3 and 4 cylinders) | Grade No.1 | 91.500 - 91.505 Millimeter (mm) |
| Grade No.2 | 91.505 - 91.510 Millimeter (mm) | ||
| Grade No.3 | 91.510 - 91.515 Millimeter (mm) | ||
| Grade No.4 | 91.515 - 91.520 Millimeter (mm) | ||
| Grade No.5 | 91.520 - 91.525 Millimeter (mm) | ||
| Grade No.6 | 91.525 - 91.530 Millimeter (mm) | ||
| Standard (except for No.3 and 4 cylinders) | Grade No.1 | 91.500 - 91.510 Millimeter (mm) | |
| Grade No.2 | 91.510 - 91.520 Millimeter (mm) | ||
| Grade No.3 | 91.520 - 91.530 Millimeter (mm) | ||
| Wear Limit | 0.20 Millimeter (mm) | ||
| Out-Of-Rount (X - Y) | Less Than 0.015 Millimeter (mm) | ||
| Taper (A - B or A - C) | Less Than 0.015 Millimeter (mm) | ||
| Main Journal Inner Diameter | No.1 Main Journal | Grade No.3 | 66.645 - 66.651 Millimeter (mm) |
| Grade No.4 | 66.651 - 66.657 Millimeter (mm) | ||
| Grade No.5 | 66.657 - 66.663 Millimeter (mm) | ||
| Grade No.6 | 66.663 - 66.669 Millimeter (mm) | ||
| Except No.1 Main Journal | Grade No.0 | 66.645 - 66.654 Millimeter (mm) | |
| Grade No.1 | 66.654 - 66.663 Millimeter (mm) | ||
| Grade No.2 | 66.663 - 66.672 Millimeter (mm) | ||
| Difference In Inner Diameter Between Cylinders | Standard | Less Than 0.05 Millimeter (mm) |